Black Friday: 50% off every paid plan with code BF50. Ends 5 December.

See prices

Blog / Editing recordings

How to make a video look like a VHS tape

A VHS look is a handful of small flaws added together. Here is what each one is, how to set it with a free browser tool, and which settings give you a worn or corrupted tape.

Short answer: open the free VHS effect tool, drop in your video, pick a look (Home video, Worn rental, Camcorder, Broken tape or Light touch), move the seven sliders until it looks right, and save an MP4. For a corrupted tape, start from Broken tape and keep the date stamp on. The tool runs in your browser, so your video is not uploaded, and your sound is kept.

This post is by the maker of MotionShine, and the tool is on this site. Facts about the tool come from its page and code. Facts about other tools come from their own pages, checked on 13 November 2026. I did not compare the results of other tools frame by frame.

What makes a video look like VHS?

Four things do most of the work. Each is one slider or switch in the tool.

The flawWhat it looks likeTool control
Scan linesThin dark lines across the picture, as on an old televisionScan lines
Colour bleedColour smeared sideways, so red runs past the edge of what is redColour bleed
Tracking noiseLines that wobble, a band of static that rolls up the picture, torn rows at the bottomTracking wobble and Noise
Date stampWhite date and time text in a corner, as a camcorder printed itStamp

Add three smaller ones: softness (an old tape holds less detail than a screen), tape wear (short bright dropouts and a flicker in brightness), and faded colour (washed out, lifted blacks, a warm tint). The tool has a slider for each.

A 2016 After Effects guide from PremiumBeat builds its look around displacing the picture itself, not only adding noise. In the tool that is the tracking wobble, so do not leave it at zero.

How do I make my video look like a corrupted VHS tape?

Use the Broken tape look, then adjust. The tool describes each look as a set of slider positions, and Broken tape sets Softness 55, Colour bleed 80, Scan lines 35, Noise 70, Tracking wobble 90, Tape wear 90 and Faded colour 50. Here is a recipe:

  1. Drop in your video and press Broken tape under Look.
  2. Press Play and watch a few seconds. The rolling band and the torn bottom rows come from Tracking wobble. The short bright dashes come from Tape wear.
  3. If it hides your subject, lower Noise and Tracking wobble first. The tool's own notes say those two change the picture most.
  4. Keep Date and time stamp on. Because the stamp is drawn before the other effects, it blurs and wobbles with the picture instead of sitting on top like a caption.
  5. Turn on PLAY label, top left if you want the word PLAY and a small triangle, as a video recorder showed on a television.
  6. Under Save, choose 480p and 4:3, old TV. 480p looks the most like tape and saves quickest. The 4:3 choice adds black bars, the shape of old televisions.
  7. Press Make the VHS video, check the result on the page, then Download the MP4.

What "corrupted" does not mean here. The tool recreates analogue tape damage: wobble, tracking bands, dropouts and colour smear. It does not freeze frames, break the picture into digital blocks, or add tape hiss to the sound. The page says no hiss is added. For a digital glitch look on a picture, the glitch effect splits colours, shifts slices and sorts pixels, and saves a PNG or a looping GIF.

What does each slider do?

All seven go from 0 to 100, and 0 means that effect is off.

SliderWhat it changesAt 0
SoftnessTakes detail out of the pictureSharp as the original
Colour bleedSmears colour, not brightness, to the sideColour stays inside its edges
Scan linesDarkens every other lineNo dark lines. At 100 the dark lines keep 55% of their brightness
NoiseAdds grain that is longer sideways than tallNo grain
Tracking wobbleSlides lines in a wave, rolls a band up the picture, tears the bottom rows, jumps the frame a littleLines stay straight
Tape wearAdds short bright dropouts and flickerNo dropouts
Faded colourTakes out colour, lifts the blacks, warms the tintColours as they were

Which look should I pick?

LookSoftness, bleed, scan lines, noise, wobble, wear, fadeUse it for
Light touch20, 20, 20, 12, 8, 8, 10A hint of retro that keeps the video clear
Camcorder35, 35, 45, 20, 15, 15, 15Clean home video with strong scan lines
Home video45, 45, 30, 30, 25, 25, 30The default, a family tape
Worn rental60, 55, 20, 45, 45, 60, 55A tape that has been played many times
Broken tape55, 80, 35, 70, 90, 90, 50A damaged, corrupted tape

Moving any slider switches the look to your own mix. The tool remembers your settings for next time, never your video.

Save settings: size, shape, frame rate and sound

  • Size. 480p, 720p or 1080p sets the height of the saved video. The picture is never stretched.
  • Shape. Same shape keeps your video's own shape. Use it for upright phone video, because 4:3 would put a tall video in a wide frame with big black bars.
  • Frame rate. It follows your video, but never goes above 30. A 60 fps video is saved at 30.
  • Sound. AAC sound is copied unchanged. Other sound is saved again as AAC in step with the picture.
  • File. You get an H.264 MP4. The tool accepts MOV, MP4 and WebM that your browser can play. A current Chrome, Edge or Safari is needed.
  • Length. The page sets no limit, but the MP4 is built in memory, so a very long video can run out of room on a small computer. Saving time grows with length, so test a short clip first.

If the tool says your browser cannot play the file, change it to MP4 first with the video converter. If the result is too large to send, the video compressor shrinks it. To cut the clip before you start, use the video trimmer.

Other ways to add a VHS look on a Mac

RouteWhat the maker's page saysWeak point
VHS effect tool (this site)Five looks, seven sliders, date stamp, MP4 with sound kept, in your browserAnalogue damage only, 30 fps cap, MP4 out
iMovieApple's guide says a sepia filter can make a clip look like old film, and a slider sets the filter's strength. The page names no VHS filterSepia is not a tape look
CapCut desktopCapCut's guide says to open Effects, choose an overlay, and adjust its opacity, blend mode and intensity. It lists grain, TV simulation and glitch effectsThe guide does not mention Mac by name
Premiere ProAdobe's tutorial uses Lumetri Faded Film, Channel Blur for colour bleed, Wave Warp for lines and Noise, on an adjustment layerThe page promotes Creative Cloud plans
KapwingLayer a VHS overlay in the browser and adjust its opacityThe start page links to a sign-in
Cloudinary toolThree looks (Worn Tape, CRT, Camcorder) and an intensity slider, output MP4, WebM or MOVYou upload your video

Checked on 13 November 2026 against each maker's page: Apple's iMovie guide, capcut.com/resource/vhs-overlay-effects, Adobe's Premiere Pro VHS tutorial, kapwing.com/tools/add-effects/vhs and cloudinary.com/tools/vhs-effect-video. Anything not in the table, for example a price or a free-plan limit for those tools, is not stated here.

Make a retro screen recording

A VHS look suits a retro-style screen demo, a music video or a short with a throwback feel. MotionShine exports MP4 (the docs say MP4 or GIF), and the tool accepts MP4, so you can record and edit in MotionShine, then run the export through the tool. Keep the look for the ending, not the whole video, if viewers need to read small text: scan lines and softness make small type harder to read. For a screen recording, try Light touch or Camcorder with the stamp on.

For more on cutting and sizing, how to edit a video on Mac goes through the basics, and how to compress a video on Mac helps when the finished file is large.

FAQ

How do I make my video look like a corrupted VHS tape?

Open the free VHS effect tool, choose the Broken tape look, keep the date stamp on, and save at 480p in 4:3. Broken tape sets tracking wobble and tape wear to 90, which gives the rolling band, torn rows and bright dropouts. It does not add digital freezes or tape hiss.

Is the VHS effect tool free, and is my video uploaded?

The tool page says there is no account and no watermark, and that every frame is drawn in your browser tab, so the video never leaves your computer. It saves an MP4.

Does the effect change the sound?

No. AAC sound is copied unchanged, and other sound is saved again as AAC in step with the picture. The tool does not add tape hiss.

What size gives the most realistic VHS look?

480p. The tool's guide says tape held far less detail than a screen, so a small frame looks right and saves quickest. Add 4:3, old TV for the black bars old televisions had.

How do I add a date stamp like an old camcorder?

Keep Date and time stamp ticked under Stamp. Change the text if you like, or press Use now for the current date and time. The stamp is drawn before the other effects, so it softens and wobbles with the picture.

Can I add a VHS effect to a long video?

The page sets no length limit, but the finished MP4 is built in memory, so a very long video can run out of room on a small computer, and saving takes longer as the video gets longer. Try a short clip first.

Make your next recording look finished.

MotionShine is free for good, with every feature. Pay only if you want bigger exports.

Listed on

Listed on JustMacAppsMotionShine on Mac App IndexMotionShine on ScrollLaunchMotionShine featured on StartupBaseFeatured on FazierFeatured on Twelve ToolsMotionShine - Featured on Smol Launch